Difference between revisions of "Using ILOM on T5120/T5220"

From Peter Pap's Technowiki
Jump to: navigation, search
(Created page with " == Default Username/Password == Username: root Password: changeme == Changing the default password == set /SP/users/root password == Sending a Break to the OS == So...")
(No difference)

Revision as of 01:28, 31 May 2011

Default Username/Password

 Username: root
 Password: changeme


Changing the default password

 set /SP/users/root password


Sending a Break to the OS

So the boot PROM on T2 processor based systems works very differently. As the boot PROM code is shared by the base OS with any LDOM's that may be present. As such, the boot PROM code is loaded into memory on startup of the hardware, or the LDOM, and then dropped. So it's not always running as it is on older systems. So in order to break to the boot PROM you need to do the following:

1. From the SP, send the break:

 set /HOST send_break_action=break

2. From the SP, start the console

 start /SP/console

3. At the console, you will see the following prompt:

 c)ontinue, s)ync, r)eset?

You want to reset, so:

 c)ontinue, s)ync, r)eset? r

4. Type #. to break out of the console and back to the SP.

5. Send the break signal again to force the boot PROM to break and stop at the OK prompt

 #.
 set /HOST send_break_action=break

6. Now start the console again to get to the OK prompt.

 start /SP/console

Seem overly complicated to you? I think so too!!