VLAN's

From Peter Pap's Technowiki
Revision as of 03:33, 21 September 2010 by Ppapa (talk | contribs) (Configure VLAN Trunking between two switches)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Creating a VLAN

  switch# config t
  switch(config)# vlan 5
  switch(config-vlan)# name engineering
  switch(config-vlan)# exit


Give ports access to VLAN

  switch# config t
  switch(config)# interface range FastEthernet0/20 - 24
  switch(config-if-range)# switchport access vlan 5


Configure VLAN Trunking between two switches

If you have two switches connected by a cross over, and there is a VLAN on each switch that you want to go over both switches, create the VLAN with the same name and number on both switches and the setup trunking as follows:


On Switch 1:

  switch# config t
  switch(config)# interface FastEthernet0/24
  switch(config-if)# switchport mode trunk
  switch(config-if)# switchport trunk allowed vlan 5

Do the same on Switch 2 and then connect the switches via a cross-over cable, port 24 to port 24.

This enable trunking on port 24, but then restricts it to just VLAN 5. You may also need to run this command:

  switch(config-if)# switchport trunk encapsulation dot1q